Wednesday 3 September 2014

Steps Followed in Door Glass Repair Surrey

Doors are mainly used for entrance and exits and sometimes as separation units. Besides security, they also reflect the outstanding interior and exterior of residences or workplaces. A broken door glass pane can create stress until it is not repaired. It needs to ensure the safety measures while repairing any door glass.

Step 1-Check the Restrictions in Area

Before undertaking door glass repair in Surrey, it is necessary to find out with your local home improvement center whether there are any restrictions in your area about glass in front and rear doors. In case of replacement, the glass should be cut according to the safety glass requirements.

Step 2-Using Safety Equipment is a Must

Gloves and safety goggles are worn while removing and discarding the broken glass. Masking tape is used for taping in a criss-cross way across the cracked pane. With the help of hammer, the glass is tapped until it breaks and then broken pieces are removed. It is important to keep the area clean of splinters and chards.

Step 3-Make the Most of Putty Knife

By using the putty knife, excess paint, glazing putty and old glaziers points are scraped away. The wood strips enveloping the glass pane are removed. Using a little pressure for doing this helps if the frame has a lot of varnish or paint on it. By varnishing or painting off, a smooth surface is created for door glass repair in Surrey.

Step 4-Adding More Flexibility

A small amount of the window putty is used for working it in hands till it gets soft and easily malleable. A thin amount is put all around the flat side of the rest area of the frame. It adds smoothness a bit with your fingers or putty knife. It will act a little adhesive to hold to glass in place.

Step 5-Installing New Door Glass

The new door glass pane is inserted into the opening and flush is used against the wooden stripes. Now, the glaziers point is used for holding it in the place. While undertaking door glass repair in Surrey, glass technicians may require pushing the points firmly with the putty knife by using at least two per side. These must be completely flushed inside the frame.

Step 6-Reinstall the Wooden Strips

Now, the wooden strips are reinstalled which you earlier removed and tapped into place. If there is any requirement to use new nails, glass technicians use very small brad nails.

1 comment: